Introduction Of Hydrostatic Gas Lubricated Bearing
Introduction Of Hydrostatic Gas Lubricated Bearing
2021年12月8日
Installation And Positioning Of Fixed Bearing
Installation And Positioning Of Fixed Bearing
2021年12月8日

NSK Anti Creep Bearing, Anti Creep Bearing Characteristics And Installation Matters

NSK anti-creep bearing is equipped with two 0-rings on the outer ring to prevent creep by limiting the clearance between the outer ring and the bearing seat. No special processing is required; Bearings can use the same bearing pedestal as standard bearings.

In the creep limit load test, under the tension of the 0-ring installed on the outer ring, the more the bearing seat clearance is reduced, the better the anti-creep effect is.

NSK Anti Creep Bearing, Anti Creep Bearing Characteristics And Installation Matters

Service characteristics of anti-creep bearing:

1. Prevent creep

The O-ring prevents creep.

2. Easy to assemble

The loose fit can be used for installation, so it is easy to assemble.

3. Reusable bearing pedestal

The wear on the inner diameter surface of the bearing seat is very small, so it can be reused.

4. No special machining of the bearing pedestal is required

Since the overall dimensions are the same as the standard bearings, the bearings can be replaced. No special treatment of the bearing pedestal is required.

 

Precautions when installing anti-creep bearing:

1. When oiling or greasing the outer diameter of the bearing, mineral oil or synthetic hydrocarbon oil (EA2 of NSK, etc.) can be used.

2. The standard 0-ring material is nitrile rubber (applicable temperature range: – 30 ~ 120 ° C). If it is to be used in special environments such as high temperatures.